Difference between revisions of "Preamplifier"
Jump to navigation
Jump to search
(Created page with "thumb|left|Preamplifier schematic") |
|||
| Line 1: | Line 1: | ||
| + | The preamplifier should increase the SiPM's weak pulse amplitude by ca. 20dB and must be located as close as possible to the SiPM. Therefore, a plug-on PCB for the SiPM board with the same form factor was designed, which shall be as versatile as possible in order to adapt for different read-out concepts with following properties: | ||
| + | * supply of the SiPM bias voltage through the preamp including bias filter | ||
| + | * AC-coupling of the preamp input | ||
| + | * based on low-noise MMIC [https://www.infineon.com/cms/en/product/rf-wireless-control/low-noise-amplifier-lna-ics/general-purpose-lnas/bga614/ BGA614] | ||
| + | * mounting option for one or two MMIC stages | ||
| + | |||
[[File:Preamp V3-1.jpg|thumb|left|Preamplifier schematic]] | [[File:Preamp V3-1.jpg|thumb|left|Preamplifier schematic]] | ||
Revision as of 21:19, 4 April 2020
The preamplifier should increase the SiPM's weak pulse amplitude by ca. 20dB and must be located as close as possible to the SiPM. Therefore, a plug-on PCB for the SiPM board with the same form factor was designed, which shall be as versatile as possible in order to adapt for different read-out concepts with following properties:
- supply of the SiPM bias voltage through the preamp including bias filter
- AC-coupling of the preamp input
- based on low-noise MMIC BGA614
- mounting option for one or two MMIC stages
