Difference between revisions of "Preamplifier"
Jump to navigation
Jump to search
| Line 7: | Line 7: | ||
[[File:Preamp V3-1.jpg|thumb|left|Preamplifier schematic]] | [[File:Preamp V3-1.jpg|thumb|left|Preamplifier schematic]] | ||
| − | [[File:Preamp sipm pcbs mounted.JPG|thumb| | + | [[File:Preamp sipm pcbs mounted.JPG|thumb|right|mounted preamp (top) and photosensor PCBs (bottom) with one instrumented SiPM]] |
[[File:Preamp_detail1.png|thumb|left|Mounted preamp plugged on the pin headers of the SiPM board of an assembled detector plate]] | [[File:Preamp_detail1.png|thumb|left|Mounted preamp plugged on the pin headers of the SiPM board of an assembled detector plate]] | ||
Revision as of 11:07, 5 April 2020
The preamplifier should increase the SiPM's weak pulse amplitude by ca. 20dB and must be located as close as possible to the SiPM. Therefore, a plug-on PCB for the SiPM board with the same form factor was designed, which shall be as versatile as possible in order to adapt for different read-out concepts with following properties:
- supply of the SiPM bias voltage through the preamp including bias filter
- AC-coupling of the preamp input
- based on low-noise Infineon MMIC BGA614
- mounting option for one or two MMIC stages
- options for preamp voltage supply: via separate connector or remote powering via output signal
