Preamplifier

The preamplifier should increase the SiPM's weak pulse amplitude by ca. 20dB and must be located as close as possible to the SiPM. Therefore, a plug-on PCB for the SiPM board with the same form factor was designed, which shall be as versatile as possible in order to adapt for different read-out concepts with following properties:

• supply of the SiPM bias voltage through the preamp including bias filter
• AC-coupling of the preamp input
• based on low-noise Infineon MMIC BGA614
• mounting option for one or two MMIC stages
• options for preamp voltage supply: via separate connector or through remote powering via output cable

Preamplifier schematic