Difference between revisions of "Hardware Setup"

From MuonPi-Wiki
Jump to navigation Jump to search
Line 1: Line 1:
 
The MuonPi HAT board is a plug-on board for Raspberry-Pi minicomputers exhibiting a 40-pin GPIO-connector. Only place the board on the RPi with power disconnected. Use 13 mm long plastic spacers and 2.5mm metric screws to fix the board.
 
The MuonPi HAT board is a plug-on board for Raspberry-Pi minicomputers exhibiting a 40-pin GPIO-connector. Only place the board on the RPi with power disconnected. Use 13 mm long plastic spacers and 2.5mm metric screws to fix the board.
 
+
= Cable Connections =
[[File:MuonPi-Connections.png|320px|thumb|Hardware connections between MuonPi HAT board and detector]]
+
[[File:MuonPi-Connections.png|480px|thumb|Hardware connections between MuonPi HAT board and detector]]

Revision as of 09:23, 4 December 2020

The MuonPi HAT board is a plug-on board for Raspberry-Pi minicomputers exhibiting a 40-pin GPIO-connector. Only place the board on the RPi with power disconnected. Use 13 mm long plastic spacers and 2.5mm metric screws to fix the board.

Cable Connections

Hardware connections between MuonPi HAT board and detector