Uploads by Hgz
Jump to navigation
Jump to search
This special page shows all uploaded files.
| Date | Name | Thumbnail | Size | Description | Versions |
|---|---|---|---|---|---|
| 23:35, 8 February 2022 | Detector-photo-phyronix.jpg (file) |  |
1.32 MB | 1 | |
| 12:37, 10 March 2021 | Ppstest-screen.png (file) |  |
22 KB | Screenshot of testing the sampling of the timepulse signal with ppstest. | 1 |
| 12:27, 10 March 2021 | Lsmod-pps.png (file) |  |
94 KB | Screenshot showing the loaded pps_gpio kernel driver module with lsmod. | 1 |
| 14:49, 10 February 2021 | User detector dl4ina.jpg (file) |  |
119 KB | Detector setup of user DL4INA | 1 |
| 19:06, 15 January 2021 | Detector-label new.png (file) |  |
217 KB | Detector Label in use since 12/2020 | 1 |
| 09:19, 4 December 2020 | MuonPi-Connections.png (file) |  |
954 KB | Description of the hardware connections to set up a MuonPi detector. | 1 |
| 10:52, 3 December 2020 | Power section v3.1.png (file) |  |
169 KB | Power management and bias voltage generation, MuonPi HAT (V3.1) | 1 |
| 10:30, 2 December 2020 | Rpi interface v3.1.png (file) |  |
211 KB | Schematic of the MuonPi RPi interface including DAC, ADC, EEPROM, temp sensor and LEDs (V3.1) | 1 |
| 10:07, 2 December 2020 | Gnss receiver v3.1.png (file) |  |
81 KB | Schematic of the GNSS receiver subcircuit of MuonPi V3.1 | 1 |
| 10:01, 23 November 2020 | Digital-pulse processor v3.1.png (file) |  |
297 KB | Digital pulse processing section of MuonPi HAT electronics (V3.1) | 1 |
| 09:43, 23 November 2020 | Input stage v3.1.png (file) |  |
176 KB | Analog input stage of the MuonPi HAT | 1 |
| 08:33, 4 September 2020 | Showersim Geant4 10TeV.png (file) |  |
130 KB | Geant4 simulation of an air shower triggered by a primary proton with kinetic energy of 10 TeV. The atmosphere is modeled in 10 layers with densities coresponding to the density calculated with the barometric formula at the heights of the layers' center. Only protons (red), negative muons (magenta) and positive muons (yellow) are shown. | 1 |
| 14:55, 3 September 2020 | Sipm pcb parts.png (file) |  |
1.21 MB | SiPM PCB mounted with one single Ketek PM3325 SiPM (right). Rubber spacer with cut-out for the SiPM to adapt the interface towards the scintillator to a planar surface (middle). VM2000 reflective adhesive foil with cut-out which is attached on top of the SiPM-rubber sandwich (right). | 1 |
